Home > Hard Drive > Booting Fails To Recognize Any Drive

Booting Fails To Recognize Any Drive

Contents

Never had this problem using IDE drives. Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Seems after awhile of plugging in and out the HDD, the connector gets to not make much/some contact with the drive. Formatting and/or recovering the drive will most likely not correct an error of this type. have a peek here

What cause this error? But Elliott did a clean install on the new drive and everything was fine. Run PSA and confirm no errors on HDD. Swapped the cables, used different ports, even removed the CMOS battery for 30 seconds.

Hard Drive Detected In Bios But Won't Boot

If that is ok, and set properly already, then I would suggest making sure that your computer is able to read from all the drives properly. Tell them you support a bipartisan bill. That way, you don't end up with a costly and ineffective solution when a simpler, cheaper one would suffice.,1.5k Views · View UpvotesRelated QuestionsMore Answers BelowWhat is the usual suspect with When your tractor breaks or your cell phone stops working, they want to be the only people who can fix it.

  1. It's obvious that it wasn't set up correctly or has other issues with the read heads or has been tampered with.
  2. Flag Permalink This was helpful (0) Collapse - how to get ride of error by hasanat60 / August 11, 2007 7:38 PM PDT In reply to: Also make sure you didn't
  3. no guarantees 0Votes Share Flag Collapse - OK here you are describing a HDD that has gone to Silicon Heaven by OH Smeg · 7 years ago In reply to BIOS
  4. Is it safe to use a HDD when rsync is working? (How) can I provide reliable water sources in a world of flying islands?
  5. The SMART technology while useful under certain circumstances had an extremely wide margin of error and would throw errors on boot occasionally when there would be nothing from either a physical
  6. It's died and is no longer working provided that the other M'Board that you tested it on is actually working that is.
  7. But when the HDD is detected to the other PC and run CHKDSK I already scan it before with the Anti Virus and found nothing.
  8. Tell them you support the bipartisan Fair Repair Act, LB 67.
  9. Google Images http://images.google.com/images?q=bad%20caps share|improve this answer answered Apr 27 '10 at 1:17 Steve 1211 add a comment| up vote 0 down vote This is what happens when you put windows on
  10. And they get to set whatever prices they want.

It requires manufacturers to provide owners and independent repair shops with access to repair information and replacement parts—so you have the resources you need to fix things quickly and affordably. I thought that it was a matter of ATA vs SATA drivers: could it be? –dag729 Apr 26 '10 at 20:11 | show 3 more comments up vote 0 down vote And they get to set whatever prices they want. Hard Drive Not Showing Up In Bios It worked for me after having tried other fixes.

Cancel mraj Rep: 1 Posted: 10/11/2015 Options Permalink History Great explanation of the problem in this video, and solution for fixing it. And then after CHKDSK is finish, I replace the SATA cable with the new and try to re-boot it after I change BIOS for this HDD as 1st boot, seems run I rebooted the computer and the hard drive is not being recognized during the boot up process. http://www.tomshardware.com/answers/id-2028429/reboot-select-proper-boot-device-problem-drive-recognized-motherboard-ssd-problem.html If you're using a PATA check the jumper settings.

by Tom Test / July 27, 2007 1:33 PM PDT In reply to: Disk boot failure: What is it and what can I do to resolve it I had a problem Hard Drive Not Detected In Bios Laptop This time luck was on my side and yes I got the cable. If you freeze it you will freeze any water inside the drive and this can kill the Magnetic Covering on the Platters which is where the data is stored. What do you call a person who is utterly independent and a loner?

Hard Drive Not Detected In Bios

I guess the contacts must have been dirty or corroded and by reconnecting them the dirt or corrosion was cleared. http://ccm.net/forum/affich-691816-sata-hdd-not-detected-in-bios-but-sometimes-it-does Note: The steps above require you to reseat the components by removing the system cover/taking apart the chassis. Hard Drive Detected In Bios But Won't Boot You hook the drive up to the adapter - outside of the host machine - and read the drive from another system as if it where just another USB mounted device. External Hard Drive Not Detected when I put it back in the macbook 13 (2009) it didn't work.

I also booted an Ubuntu livecd on the system. navigate here I have the following configuration. I even got it to work once or twice on boot up, but never again. Be sure to check your SATA cables are tightly connected to the SATA port connection.The easiest way to test a cable is to replace it with another cable.  If the problem Internal Hard Drive Not Detected

It takes less than a minute and is completely free! And they get to set whatever prices they want. I hope you are not expecting a reply from that poster.Why don't you use one of the forum links in the left hand column to go to an appropriate forum and Check This Out When I turn the computer on, the HDD led lights up as if it is trying to access the drives, then the CD drive cycles as if it is trying to

Proffitt Forum moderator / September 23, 2011 4:03 AM PDT In reply to: disk error I think either the solution was told here or you need to install the OS and How To Get Bios To Recognize Hard Drive Could of course be a defective SSD. 12/29/2015 by asle Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? We will await your response.

Leave that to a professional.Rather, open the computer and check:Drive mounting.

Tell them repair is good for the environment, good for consumers, and good for businesses. It requires manufacturers to provide owners and independent repair shops with access to repair information and replacement parts—so you have the resources you need to fix things quickly and affordably. Stand up for the right to repair in Nebraska. Hard Drive Not Detected Windows 10 There is usually a cover with several screws holding it in place on the bottom of the computer.

Pressing F2 and entering the BIOS set-up utility was unnecessary for me.The only thing left is to re-set the date and time, though if the box (in Date and Time Properties, If you have good power and good cabling then the drive is bad. Please try again now or at a later time. this contact form Tell them repair is good for farmers, good for consumers, and good for businesses.

Take Action It's time to speak out for your right to repair Dear Nebraskans, This year, the people of Nebraskans have a chance to guarantee their right to repair their equipment—like Restart my PC> This provides me with a temporary fix ONLY but not permanent as the problem continues to take place. 3 weeks ago I replced the CMOS battery and my Flag Permalink This was helpful (0) Collapse - Also make sure you didn't leave any floppy discs or CDs in by Technojunkie3 / July 27, 2007 1:13 PM PDT In reply by 4Denise / July 27, 2007 3:00 PM PDT In reply to: Disk boot failure: What is it and what can I do to resolve it Ordinarily, I'd tell you to

But it’s not going to be easy. SpinRite. 0Votes Share Flag Back to Hardware Forum 12 total posts (Page 1 of 2)   01 | 02   Next Search Start or search Start A Discussion Start A Discussion The Fair Repair Act, or LB 67, is simple. When your tractor breaks or your cell phone stops working, they want to be the only people who can fix it.

My hat is off to you...thank you, Thank you, THANK YOU! 06/14/2015 by Jay Ell This worked great! Don't show these FacebookTwitterEmailPrintGmailFavoritesMore... (294)Powered byAddThis The BIOS does not detect or recognize the ATA / SATA hard driveThere are six main reasons why a system BIOS will not detect the presence of an If the Hard Drive is detected, one of the SATA ports on the motherboard is bad. Anyway, if not the motherboard or the drive, could be the power supply.

You want the tape to reduce the inner space so that it forces the metal pins to make better contact, being careful not to place the tape over the metal pins The mac booted normally. New coworker puts on disturbing shows and music on the store TV Example of an algorithm that lacks a proof of correctness Objects that can be initialized but not assigned Enthusiastically Maybe a free replacement is possible?

Was this answer helpful? This thread was invaluble to me diagnosing the problem. cut tape very close to the edge.